3D Printed One-Inch Brake/Cluch Reservoir Ball Mount
Post Reply    Forum -> Project Reports
Author Message
MP3 500
Joined: 24 Oct 2010
Posts: 264
Location: Columbus OH USA
Wed Jun 27, 2018 5:45 am quote
Here's my One-Inch Brake/Clutch Reservoir Ball Mount. Use this to attach Ram Mount accessories to the top of your clutch/brake reservoir. Remove the two M4 bolts and replace them with longer M4 by 18mm bolts. Measure your reservoir with a set of calipers and click Open in Customizer to fine-tune dimensions...

Released under Creative Commons - Attribution license.
Joined: 10 Jul 2009
Posts: 324

Thu Oct 04, 2018 8:43 am quote
That's a good idea, instead of adding additional clamps and things.
Molto Verboso
Vespa GTS 250ie
Joined: 02 Jun 2015
Posts: 1157
Location: San Francisco Bay Area
Thu Oct 18, 2018 8:27 am quote
Very nice!
Have you found material that is not damaged by brake fluid?
Scooting the Ozarks is a scooter rally held in Eureka Springs, Arkansas offering riders scenic twisty rides, poker run, and more.   Vespa Wasp Pin Badges   Cool Ass scooter seat cover
Post Reply    Forum -> Project Reports
[ Time: 0.2263s ][ Queries: 25 (0.0398s) ][ Debug on ]