1978 VBC using a 2005 PX150e crankshaft
Post Reply    Forum -> Not-So-Modern Previous12
Author Message
Molto Verboso
One or two fun scoots....nothing too precious
Joined: 17 Jul 2013
Posts: 1110
Location: UK (South East)
Tue May 28, 2019 10:21 pm quote
I think you need to establish if the PX150 crank is out of spec. How did you measure the 97.2 and 97.9? I have two PX150 cranks on the shelf and can measure for comparison.
Enthusiast
2008 LX 50 & 1978 150 Super
Joined: 29 Aug 2013
Posts: 54
Location: Connecticut
Tue Jun 04, 2019 2:45 am quote
PX spec question
This crankshaft came out of a scooter that was factory built in 2005. The SW guy is upgrading the factory scooter. These are the parts he pulled for the upgrade. Also got the cylinder, piston and head.
Enthusiast
2008 LX 50 & 1978 150 Super
Joined: 29 Aug 2013
Posts: 54
Location: Connecticut
Tue Jun 11, 2019 6:12 pm quote
So far, so good
Here are the results

Ground lip.jpg

Hooked
Honda elite
Joined: 19 Jun 2007
Posts: 499
Location: California
Tue Jun 11, 2019 8:15 pm quote
I sure hope that works. I had some interference on the rotary pad when the crank was only in the clutch side bearing, when the other case half installed that issue went away
2019 Fall Gathering - September 12 - 15, Hungry Mother State Park, Marion, VA   Vespa Wasp Pin Badges   Scooter Parts Company
Post Reply    Forum -> Not-So-Modern Previous12
[ Time: 0.2640s ][ Queries: 25 (0.0599s) ][ Debug on ]