Cush drive rebuild - bearing stuck?
Post Reply    Forum -> Not-So-Modern
Author Message
Member
PX200E
Joined: 01 Oct 2012
Posts: 15
Location: Philadelphia, PA
Thu Aug 22, 2019 5:58 pm quote
Rebuilding my cush drive on a 1999 PX200 (vse). So far, got all the rivets out, springs out. Removed the circlip and tapped on the shaft pretty hard, but the bearing doesn't seem to want to come out. Looking in the bearing side, it seems like there is a seat or something on the outside? I don't want to hit the shaft any harder than I already have, any suggestions?

The bike is a VSE1M PX200, disc, with cosa clutch.
Ossessionato
73 Rally, 74 Rally, 76 ET3, 80 P200, 63 Li125, 65 Li225 Silver Special, 86 Elite 80, 2015 HD Road Glide Special, 2011 Ural Tourist
Joined: 18 Jan 2012
Posts: 3227
Location: Oceanside/ SF
Thu Aug 22, 2019 6:02 pm quote
http://www.scootermercato.com/Garage/Tech-Tips/Cush-Drive-Rebuild

Got any punches to narrow down the force being applied?
Member
PX200E
Joined: 01 Oct 2012
Posts: 15
Location: Philadelphia, PA
Thu Aug 22, 2019 6:04 pm quote
Is it cool to use a punch on the end of that shaft? I nailed it pretty hard with a deadblow hammer while standing it on two studs to let the shaft fly free.
Member
PX200E
Joined: 01 Oct 2012
Posts: 15
Location: Philadelphia, PA
Thu Aug 22, 2019 6:05 pm quote
Oh sorry, to be clear the bearing is still in the gear stack.
Member
PX200E
Joined: 01 Oct 2012
Posts: 15
Location: Philadelphia, PA
Thu Aug 22, 2019 6:12 pm quote
Wailed the balls off it with a bigger hammer . Thanks for the courage.
Missouri Loves Company Rally   vespa scooterwest scooter west Motorsport Scooters   Cool Ass scooter seat cover
Post Reply    Forum -> Not-So-Modern
[ Time: 0.2268s ][ Queries: 24 (0.0484s) ][ Debug on ]