OP
UTC

Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
 
Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
UTC quote
I'm dyin to know where it is and how to access the BV 350 idle adjustment
screw.

It's been stalling at idle. I'll reset the ECU by disconnecting the battery. If that doesn't do anything, I'll adjust for slightly faster idle and see if that works.

I'm bringing it in for the first service on Tuesday. I'd like not to stall at red lights until then.

Thanks!
@papa_smurf avatar
UTC

Molto Verboso
GTS250ie, ET4
Joined: UTC
Posts: 1244
Location: cincinnati, ohio, usa
 
Molto Verboso
@papa_smurf avatar
GTS250ie, ET4
Joined: UTC
Posts: 1244
Location: cincinnati, ohio, usa
UTC quote
Id bet the Fuel Injector needs cleaning. Use 1-2 oz of seafoam in a tank of gas and I bet your idle problem goes away.

PS on my GTS there is a Idler adjustment screw but I have been told not to mess with that In 7 years and 35000 miles I have never messed with it.
@syd avatar
UTC

Veni, Vidi, Posti
GTS300 Super (Mustard) GTS250 Super (Bulger)
Joined: UTC
Posts: 5339
Location: Tempe, AZ
 
Veni, Vidi, Posti
@syd avatar
GTS300 Super (Mustard) GTS250 Super (Bulger)
Joined: UTC
Posts: 5339
Location: Tempe, AZ
UTC quote
Re: BV 350 Idle adjustment screw
gtsrider wrote:
I'm dyin to know where it is and how to access the BV 350 idle adjustment
screw.

It's been stalling at idle. I'll reset the ECU by disconnecting the battery. If that doesn't do anything, I'll adjust for slightly faster idle and see if that works.

I'm bringing it in for the first service on Tuesday. I'd like not to stall at red lights until then.

Thanks!
Is it consistent or until it worms up? Mine did that but only until it warmed up, and on only two occasions.
OP
UTC

Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
 
Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
UTC quote
Papa Smurf wrote:
Id bet the Fuel Injector needs cleaning. Use 1-2 oz of seafoam in a tank of gas and I bet your idle problem goes away.

PS on my GTS there is a Idler adjustment screw but I have been told not to mess with that In 7 years and 35000 miles I have never messed with it.
I'm going to do that cause it can't hurt. If it doesn't help, I just avoid complete stops until the first service

Good numbers on the GTS! I traded mine for the BV. It was hard to see her go.

Thanks.
OP
UTC

Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
 
Member
2015 GTS 300
Joined: UTC
Posts: 8
Location: CT
UTC quote
Re: BV 350 Idle adjustment screw
[/quote]
Is it consistent or until it worms up? Mine did that but only until it warmed up, and on only two occasions.[/quote]

It's consistent at red lights, even when warm. I'm sure it'll be fixed with minor adjustments at first service. Thanks.
@papa_smurf avatar
UTC

Molto Verboso
GTS250ie, ET4
Joined: UTC
Posts: 1244
Location: cincinnati, ohio, usa
 
Molto Verboso
@papa_smurf avatar
GTS250ie, ET4
Joined: UTC
Posts: 1244
Location: cincinnati, ohio, usa
UTC quote
Give it a try. I use SeaFoam in both my wifes BV250 (Carb Model) and my GTS. Seems like after every 3-5 tanks of gas the idle will drop down low enough that sometime it will just die when you come to a stop. Most of the time within 25-50 miles after putting seafoam in the gas the problem goes away.

Good luck
@scooter10s avatar
UTC

Hooked
2001 ET4 150 Red, 2010 GTS 300 Volcano Black, 2013 BV 350 Silver/Black
Joined: UTC
Posts: 408
Location: Bergen County, NJ
 
Hooked
@scooter10s avatar
2001 ET4 150 Red, 2010 GTS 300 Volcano Black, 2013 BV 350 Silver/Black
Joined: UTC
Posts: 408
Location: Bergen County, NJ
UTC quote
Clogging injectors on an new engine that's only been out for a little over a year, hmmmm, hard to believe?

I had the same problem last month.

Dealer told me there is no idle adjust screw on the BV 350, it's 100% electronically controlled.

Dealer fixed idling/stalling problem, stating it was a likely fuel overfill that wetted the EVAP canister and roll over valve setup, requiring disassembly and drying out with compressed air. Good luck!
@old_as_dirt avatar
UTC

Veni, Vidi, Posti
2007 GTS
Joined: UTC
Posts: 23390
Location: Harriman, Tennessee, Tn
 
Veni, Vidi, Posti
@old_as_dirt avatar
2007 GTS
Joined: UTC
Posts: 23390
Location: Harriman, Tennessee, Tn
UTC quote
curious to see what the spark plug looks like. Also what gas are you using ? brand and octane rating?

have you cleaned the air filter?
@dooglas avatar
UTC

Veni, Vidi, Posti
GTS 300ABS, Buddy Kick 125
Joined: UTC
Posts: 13560
Location: Oregon City, OR
 
Veni, Vidi, Posti
@dooglas avatar
GTS 300ABS, Buddy Kick 125
Joined: UTC
Posts: 13560
Location: Oregon City, OR
UTC quote
gtsrider wrote:
Papa Smurf wrote:
Id bet the Fuel Injector needs cleaning. Use 1-2 oz of seafoam in a tank of gas and I bet your idle problem goes away.
I'm going to do that cause it can't hurt. If it doesn't help, I just avoid complete stops until the first service
Clogged injector on a new 350 with only a few hundred miles on the clock doesn't seem likely (though, as you say, Seafoam can't hurt ). Also, the idle should automatically reset.

Modern Vespa is the premier site for modern Vespa and Piaggio scooters. Vespa GTS300, GTS250, GTV, GT200, LX150, LXS, ET4, ET2, MP3, Fuoco, Elettrica and more.

Modern Vespa is made possible by our generous supporters.

Buy Me A Coffee
 

Shop on Amazon with Modern Vespa

Modern Vespa is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com


All Content Copyright 2005-2026 by Modern Vespa.
All Rights Reserved.


[ Time: 0.0105s ][ Queries: 3 (0.0042s) ][ live ][ 343 ][ ThingOne ]