Forum -> General Discussion
Search Topic
et2 head nut torque setting?
OP
@madhillbilly17 avatar
madhillbilly17
UTC
Enthusiast
et2
Joined: UTC
Posts: 85
Location: in my garage
 
madhillbilly17
Enthusiast
@madhillbilly17 avatar
et2
Joined: UTC
Posts: 85
Location: in my garage
UTC quote
Hi guys,i just started to refit my head on my et2 50cc 2 stroke, haynes manual says 22-23 nm for the head nuts so i set my torque wrench to 15 nm then 19nm then snap! anyone know if 22-23nm is right for sure? just seen a video on you tube and the guy did 14nm any help would be great thanks Dan.
OP
@madhillbilly17 avatar
madhillbilly17
UTC
Enthusiast
et2
Joined: UTC
Posts: 85
Location: in my garage
 
madhillbilly17
Enthusiast
@madhillbilly17 avatar
et2
Joined: UTC
Posts: 85
Location: in my garage
UTC quote
scrap that lol,bloody haynes there are so many other models i went off the page that said 2 stroke at the top but didn't see the model written further down! found it now 10-11 nm new stud ordered
@motovista avatar
Motovista
UTC
Veni, Vidi, Posti
GT 200
Joined: UTC
Posts: 9299
Location: Main Street, Watts
 
Motovista
Veni, Vidi, Posti
@motovista avatar
GT 200
Joined: UTC
Posts: 9299
Location: Main Street, Watts
UTC quote
You are lucky you didn't pull the stud out of the case. It's about 10-12 f/p on most 2T 50cc engines.
Post Reply
Forum -> General Discussion

Modern Vespa is the premier site for modern Vespa and Piaggio scooters. Vespa GTS300, GTS250, GTV, GT200, LX150, LXS, ET4, ET2, MP3, Fuoco, Elettrica and more.

Modern Vespa is made possible by our generous supporters.

Buy Me A Coffee
 
Shop on Amazon with Modern Vespa

Modern Vespa is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com

All Content Copyright 2005-2025 by Modern Vespa.
All Rights Reserved.

[ Time: 0.0105s ][ Queries: 3 (0.0044s) ][ live ][ 334 ][ ThingOne ]