Modern Vespa

I want to change the belt and rollers on my ET4 Leader but I can't find the how to do it on this site. I am sure I have seen it here somewhere, but now that I want it I can't find it. Can someone point me to the right page please.

Thanks for your help, Rick.

I don't think I've seen one specifically for the ET4, but there is this one for the GT200. It's similar(ish). I would double check any torque settings if any are mentioned in there.

if you've got a Leader engined ET4 then the procedure is almost identical to the GT and GTS - all of the same principles (torquing nuts to correct spec, seating the belt properly, putting the rollers in the proper orientation) apply.

Many thanks to TheJ and genie. Job is done and running sweetly.
I am sure it is the 1st replacement belt on this bike. It's done 23000km and I got it at 7000km. It has never been replaced since I have owned it.

Thanks, Rick

Nae bother Rick, glad to hear it went well.

All those miles on the original belt? Your bum must have been beginning to twitch a bit surely!

I must say I was starting to feel a bit nervous each time I took it out. The old belt looked to be in pretty good condition apart from some hairline cracking between the teeth. Rick